To Next PageTo Next Page
Need help?Do you have a question about the Technaxx TX-83 and is the answer not in the manual?
General| Type | IP security camera |
|---|---|
| Placement supported | Indoor |
| Connectivity technology | Wired |
| Form factor | - |
| Mounting type | Wall |
| Product color | Black |
| Protection features | Dust resistant |
| International Protection (IP) code | IP65 |
| Full HD | No |
| Total megapixels | 1 MP |
| Maximum resolution | 1280 x 720 pixels |
| Supported video modes | 720p |
| Video formats supported | H.264 |
| Image quality adjustment | Brightness, Contrast, Saturation, Sharpness |
| Supported graphics resolutions | 1280 x 720 (HD 720) |
| Tilt angle range | 70 - 80 ° |
| Camera shutter speed | 1/100000 s |
| Minimum illumination | 1 lx |
| Sensor type | CMOS |
| Optical sensor size | 1/4 \ |
| Ethernet LAN | Yes |
| Wi-Fi standards | 802.11b, 802.11g, Wi-Fi 4 (802.11n) |
| Cabling technology | 10/100Base-T(X) |
| Supported network protocols | TCP, IP, HTTP, DHCP, DNS, DDNS, SMTP, NTP |
| Detection distance | 10 m |
| Focus adjustment | 1.2 |
| Focal length range | 0 - 3.6 mm |
| Compatible memory cards | MicroSD (TransFlash) |
| Maximum memory card size | 64 GB |
| Audio formats supported | G.711 |
| Signal-to-Noise Ratio (SNR) | 40 dB |
| Ethernet LAN (RJ-45) ports | 1 |
| DC output current | 2 A |
| DC output voltage | 12 |
| Power source type | DC |
| Power consumption (max) | 16 W |
| Operating temperature (T-T) | -10 - 60 °C |
| Operating relative humidity (H-H) | 0 - 90 % |
Weight and Dimensions| Width | 150 mm |
|---|---|
| Height | 200 mm |
| Weight | 1200 g |
Guide to installing the mobile application for remote camera control.
Step-by-step guide for initial camera setup via access point.
Procedure for finding the camera on the local network.
Instructions for connecting the camera to a WiFi network.
Configuration of LED light operation modes (manual/auto).
Setting the light level for automatic Day/Night mode switching.
Adjusting the sensitivity of the PIR motion sensor.
Configuring push notifications for PIR and motion detection events.
Configuring WiFi connection using the web browser interface.
Configuring motion detection and alarm trigger parameters.
