Compatible with the TX-128 Set: TX-145 (outside); TX-146 (inside)
Step one: Power on the monitor and camera. (Normally when adding an
additional camera you are using the monitor already so it should be powered
on.)
Step two: Reset the camera to enter the pairing mode.
→ Therefore click the reset button on the cable end. It is hidden under a
cover.
→ Press the button until the camera speaks to you.
Step three: Enter the code interface on the monitor and click on the match
code.
→ Go to the main menu and choose the setting Match Code.
→ On the next interface you will see the max camera amount and their
status.
→ Click the button Match Code to start the pairing.
Tips:
1) The camera can only perform the pairing in the reset state, reset the
camera. Notice: If the camera was already connected with the monitor and
you deleted from the connection list you can easily connected it again by
using “Match Code”.
2) If the camera does not pair with the monitor, click “Match Code” again to
try again. Or reset the camera again.
3) If you need to replace a new camera, please click "X" to delete the
channel and then click on match code.
To Next Page
Loading...
Need help?
General
