10
Playing a vinyl record ( ! IMPORTANT ! )
When using the turntable, make sure to remove the stylus protector (2). It
should easily slide off the cartridge stylus assembly (1). Furthermore, make
sure to unclip the tone arm lock before use and to secure it again after use.
⚫ Turn on the unit and adjust the volume to an appropriate level.
⚫ Turn the function knob to the PHONO position.
⚫ Place a record on the turntable platter and select the correct player speed:
33/45/78rpm according to the vinyl being played. When playing a 45rpm
record, use the included 45rpm adaptor.
⚫ Set the auto/manual stop control: Set the auto stop switch to ON to stop
the turntable turning when the record is finished. If the switch is set to OFF,
the turntable will continue turning.
⚫ Remove the stylus guard and unlock the tone arm lock.
⚫ Push the lift lever up to raise the tone arm and then gently move the tone
arm to the desired position over the record.
The platter will begin to spin when the tone arm is moved toward the record.
Push the cue-lever (22) forward to lower the tone arm slowly onto the
desired position on the record. The record will begin playing.
⚫ If the auto switch (20) is turned to ON, the record will stop playing
automatically. If it is set to OFF, the record will not stop automatically.
⚫ When the record is finished, push the cue-lever (22) backwards to raise
the tone arm and gently move it back to its rest position.
⚫ When you have finished playing records, engage the tone arm lock to
protect it from accidental movement. Unplug it from the power supply if it is
not going to be used for a while.
To Next Page
Loading...
Need help?
General
