Technica Engineering 100/1000BASE-T1 MEDIACONVERTER MATEnet User Manual

100/1000BASE-T1 MediaConverter MATEnetUser Manual
13
2.1.4 Micro HDMI Debug Connector (4)
The micro HDMI debug connector is not to be used by the user. It is for development
only. The required debug cable and extension board are not part of delivery and cannot
be ordered.
This is not a video interface.
2.2 DIP Switches (5)
These DIP Switches are for configuration. You can find more information about
configuration in CHAPTER 3.1
2.3 Status LEDs (6)
The 100/1000BASE-T1 MediaConverter has 5 LEDs on the front side of the case.
LED
Description
Host LED
Will blink slowly(once a second), during normal operation of the device.
GP LED
General Purpose LED. Will be lit when the microcontroller detects an active
100/1000BASE-T1 link.
Error LED (red)
Will be lit when at least one CRC error is detected. This may happen when the
MATEnet connector is plugged during operation.
Link LED
100 or 1000Base-T1 Link active.
Activity LED
100 or 1000Base-T1 Ethernet data transmission.
Table 2-5 LED Description
The 100/1000BASE-T1 MediaConverter has LEDs integrated in the RJ-45 connector.
For RJ45 connection:
Left side: Green = 100 BASE-TX link
Orange = 1000 BASE-T link
Right side: Orange = ACTIVITY

Technica Engineering 100/1000BASE-T1 MEDIACONVERTER MATEnet Specifications

General

Brand	Technica Engineering
Model	100/1000BASE-T1 MEDIACONVERTER MATEnet
Category	Media Converter
Language	English