18
2
SETUP
DMS-CTC-20131021-0004 v1.0
2.3 Connect your wired devices
Requirements
Both your network device (for example, a computer, a gaming console, etc.) and Gateway must have a free Ethernet port.
Your network device must be configured to obtain an IP address automatically. This is the default setting.
All Ethernet ports on the Gateway are Gigabit Ethernet ports and have a maximum speed of 1 Gbps (Gigabit per second).
Procedure
Proceed as follows:
1 Take the yellow Ethernet cable that is included in your box.
2 Plug one end of the Ethernet cable into one of the yellow Ethernet ports on the back of the Gateway:
3 Plug the other end of the Ethernet cable into the Ethernet port of your network device.
4 Your network device is now connected to your network. Use the same procedure to connect your other Ethernet devices
(computers, network printers and so on).
SN: CPYYWWPPXXX
CM MAC: 00111100ABCD
To Next Page
Loading...
