29
3 ADMIN TOOL
DMS-CTC-20131021-0004 v1.0
3 Admin Tool
Introduction
The Admin Tool allows you to configure the settings of your Gateway via your web browser, using a computer or device that is
currently connected to you Gateway (either wired or wirelessly).
Requirements
JavaScript must be enabled on your browser (this is the default setting). For more information, consult the help of your web
browser.
Accessing the Admin Tool
Proceed as follows:
1 Open your web browser and browse to http://10.0.0.1, using a computer or device that is currently connected to you Gateway
(either wired or wirelessly).
2 The Gateway prompts you to enter the username and password. Enter your user name (default: admin) and password
(default: password) and click OK.
On Windows it is also possible to access the Admin Tool using UPnP. For more information, see “7.1.1 UPnP” on
page 56.
10.0.0.1 is the default IP address of the Gateway. If at some point you changed the IP address of the Gateway,
use the new IP address instead.
To Next Page
Loading...
