Technicolor TC8717C - How to Manually Connect Your Wireless Client

22
2
SETUP
DMS-CTC-20131021-0004 v1.0
2.4.2 How to manually connect your wireless client
Requirements
 Your network device must be equipped with a Wi-Fi Certified wireless client.
 Your network device must be configured to obtain an IP address automatically. This is the default setting.
Procedure
If you want to connect a computer using the wireless network, configure the wireless client on your computer with the wireless
settings printed on the Gateway's side or back panel label.
To configure these settings on:
 Windows 8, proceed with “How to connect your computer on Windows 8” on page 23.
 Windows 7, proceed with “How to connect your computer on Windows 7” on page 23.
 Windows Vista, proceed with “How to connect your computer on Windows Vista” on page 24.
 Windows XP, proceed with “How to connect your computer on Windows XP” on page 25.
 Mac OS X, proceed with“How to connect your computer on Mac OS X” on page 26.
 On another operating system, consult the help of your wireless client or operating system.
For the network name, two values are available:
 Network Name 1 (SSID) is the network name of the 5 GHz access point and is of the following format:
HOME-XXXX-5 (where X is an alphanumeric character).
 Network Name 2 (SSID) is the network name for the 2.4 GHz access point and is of the following format:
HOME-XXXX-2.4 (where X is an alphanumeric character).
The other values are common for both access points.
Network Name 1 (SSID) : ***************
Network Name 2 (SSID) : ***************
Password : ***************
Encrytion : ***************
or