FIGURE 4 – NBN READY
FOR TRANSITION TO PHONE
SERVICE ONLY (FTTB OR FTTN)
This configuration applies if you have an existing working home phone service and
you want it to work with your new HNG device before the changeover to the NBN.
1. Connect your HNG as shown in the figure below. Then follow the instructions
under ‘Step-by-Step Guide to Installing the HNG’ on page 6.
2. To avoid interference and performance degradation, the HNG must be connected
to the main telephone socket in your premises on its own, with all other internal
cabling and existing telecommunications equipment disconnected (e.g. facsimile and
security alarms). If required, a qualified licensed cable installer or electrician can
re-connect your internal in-home cabling as shown in the diagram with a dotted line.
3. After transition to the NBN, your new home phone service will operate directly from the HNG.
Your old home phone service will now no longer be active.
4. The filter is now no longer required so you can now connect your HNG DSL port directly to the
main telephone socket, using the same grey phone cable. The grey phone cable to the HNG
PSTN port can also now be disconnected.
To Next Page
Loading...
