Technics QUARTZ SA-GX100 User Manual

It
Tuner section
[22] Power “standby (b/on” switch ©
(power! m standby () = on)
\f
the
power
was
switched
OFF
from
the
remote
control,
to
switch
the
power
ON
from
the
unit
set
the
switch
to
OFF
and
then ON again.
Note:
The
power
can
not
be
controlled
from
the
remote
control
uniess
this switch is set to ON.
[23]
Remote-control
signal
receptor
(remote
sensor)
Receives
the
signals
from
the
remote-control.
[24]
“standby
”
indicator
(standby)
;
This
indicator
illuminates
when
the
power
switch
of
this
unit
or
that
of
the
remote
control
is
switched
“OFF”.
Its
purpose
is
to
alert
the
user
of
the
constant
supply
voltage
to
the
internal
cir-
cuitry
even
with
the
power
switch
OFF.
(25)
Preset
channel
matrix
display
(tuner
matrix)
When
an
entry
is
made
into
memory,
the
bar
under
the
figure
il-
luminates.
The bar
of
the
“channel”
now
being
received
flashes
con-
tinuously.
Band indicators (AM/FM)
Indicates the selected band.
FM stereo indicator (FM ST)
This
indicator
automatically
illuminates
when
an
FM
stereo
broadcast is being received.
Note:
It
will
not
illuminate
if
the
FM
mode
selector
is
set
to
the
monaural mode.
Quartz-lock
indicator
(quartz
lock)
This
indicator
illuminates
when
the
unit
is
tuned
precisely
to
a
broadcast
station.
Sven Gilt)
~ [29|Memory indicator (memory)
This
indicator
illuminates
when
the
memory
button
is
pressed.
[30] Audio input selector/frequency display
(input selector/frequency)
Displays the selected source or broadcast frequency,
34] Memory-scan/group-search button
(memory scan/— group search)
This
button
is
used
to
scan
the
memory
presets
within
a
group
(for
about
three
seconds
each)
or
to
search
for
the
desired
group.
32] Tuning buttons (tuning)
These
buttons
are
used
for
tuning
to
the
desired
broadcast
sta-
tion.
The
frequency
will
change
at
intervals
of
0,1
MHz
for
FM
and
10
kHz
for
AM.
(33| Memory button (memory)
This
button
is
used
when
presetting
broadcast
station
frequen-
cies into memory.
Preset-tuning buttons (1—0)
(24 channel random preset tuning)
These buttons are used to preset broadcast frequencies into
the memory of this unit and to recall the desired prese| Stations.
(35|Group registration buttons (group)
These buttons are used to assign memory preseis to the
desired group or to select the desired group.
Band selectors
FM: Press this button to listen to an FM broadcast.
AM: Press this button to listen to an AM broadcast.
FM mode selector (FM mode)
This unit automatically switches to the stereo mode when an
FM stereo broadcast is received. This selector is used to select
the mode (stereo or monaural) of FM broadcast sigm is.

Technics QUARTZ SA-GX100 Specifications

General

Brand	Technics
Model	QUARTZ SA-GX100
Category	Stereo Receiver
Language	English