Technics QUARTZ SA-R177 - Initial Setup and Operation; Pre-Operation Guide; Remote Control Operation; Included Accessories

Mi BEFORE USE
Be sure to disconnect the mains cord before adjusting the
voltage selector.
Use a minus (—) screwdriver to set the voltage selector (on the
rear panel) to the voltage setting for the area in which the unit
will be used.
Mi REMOTE-CONTROL OPERATION
Tuner controls
play >
Compact disc player controls
Ped ShID dor
Mi ACCESSORIES
e@ AM loop antenna (1)
(SPB1162T)
FM indoor antenna (1)
(SSA269M)
e Screws (2)
(XTN3+10AFZ)
®Remote-control
transmitter (1)
(EUR64747)
®@ Flat cable for remote-controi (1)
(SWKST11M—1)
AM ‘FM preset tuning
co
Pplay Bye Use
See
Techni
Remote Controt Transmitter
System
SA-R177
(If the power supply in your area is 117 V or 120 V, set to the
“127 V" position.)
Note that this unit will be seriously damaged if this setting is not
made correctly. (There is no voltage selector for some countries;
the correct voitage is already set.)
Amplifier controls
eck
Bstoc sMoause
Cassette deck controls
Gise
C4
Disc number controls
ferries
AM antenna holders (2)
(SMA233—1M)
(SMA231M)
e AC power supply cord (1)
(RJA0004)
(SJA173)
@ Connection cable for
remote-control (1)
(SJP2257T)
© Batteries (2)
(UM-4NEP/2S)