Technics Quartz SA-R230 - Page 8

Ref. No. How to remove the balance control Ref. No. ,
: P.C.B. and volume P.C.B. How to remove the key switch P.C.B.
Procedure
|
4
Remove
the
balance
control
knob.
1.
Remove
the
2
screws
(@,
@),
and
1>2->4-7]
92.
Remove
the
2
screws
(@,
@).
Imes4nd
remove
the
P.C.B.
holder.
3.
Remove
the
balance
control
P.C.B.
2.
Remove
the
2
screws
(@,
@).
4. Remove the 3 screws (@~®6). 3. Remove the 2 tabs.
5.
Remove
the
volume
P.C.B.
4.
Remove
the
key
switch
P.C.B.
Balance control knob Ref. No
How to disassemble the remote control
Procedure | 4 Remove the Battery cover lid.
Mounting main volume control 9
1. Insert the motor volume shaft into volume base
(@) and secure it with nut (©).
2. Insert the shatter plate (©) into volume knob (@),
then mount the volume light guide (@), volume
knob, and volume ring (@) on the volume shaft.
Note: Slip one end of the shatter plate eee
inside the volume light guide.
2. Insert a flat blade screwdriver between the upper
and lower covers inside the battery compartment
and then slowly loosen the bottom cover.