Technics RS-TR165 Operating Instructions

About
Cassette
Tapes
Remove the erase-prevention tabs (thus preventing recording).
Selection of cassette tapes
Do not use the following types of tapes in this unit.
¢ 120-minute (or longer) tapes
Because the tape is very thin, it might stretch during use caus-
ing unstable tape movement which may result in the tape
becoming tangled in the rotating parts of this unit.
° Fe-Cr tapes (TYPE Il)
The high frequency range will be emphasized and it will not
be possible to obtain a flat frequency response.
¢ Metal tape without detection holes
Recording will be very distorted. (There is no playback problem,
however.)
Metal
tape
Ca
(ery
Detection holes
Tape slack
This may cause the tape to break.
Use a pencil or similar
object to take up the
slack.
Use a screwdriver
or similar object to
break out the tab.
Tab for side “A”
Tab for side ‘“B”
To
re-record
on
a
protected
cassette
Cover the slot with adhesive
tape.
Attach tape.
Avoid tape storage in the following
places
Tape can be damaged if it is stored in places such as described
below.
Where the temperature is high (95°F/35°C or higher) or where
the humidity is high (80% or higher).
Where there is a strong magnetic field (near a speaker, on top
of a TV, etc.).
ein direct sunlight.
Do not place near magnetic object,recording will be erased.

Technics RS-TR165 Specifications

General

Brand	Technics
Model	RS-TR165
Category	Cassette Player
Language	English