Technics RS-TR252

The procedures described below are an example of playback on
Deck 2.
POWER Press POWER.
(The unit will switch on.)
ogiaYNR ~—- Press either DOLBY NR B or
OO C to select the appropriate
noise-reduction system.
6 Press if the tape was recorded by the type-B Dolby NR
system.
{The [B) Dolby noise-reduction indicator will then il-
luminate.)
6 Press if the tape was recorded by the type-C Dolby NR
system.
(The |C} Dolby noise-reduction indicator will then il-
luminate.)
Dolby noise-reduction indicator ( [B] or [C])
\f neither Dolby noise-reduction system was used, press
the button corresponding to the Dolby noise-reduction in-
dicator that is iuminated. (The indicator will then switch
OFF.)
REVERSEMODE Press I~, Gt or Od to
select the desired reverse
mode.
Reverse-mode indicator (——, Ct or Xt)
3: One side only.
>): Both sides repeatedly (up to 8 times).
&: Both sides, once only.
(Refer to page 7.)
Press <q PLAY or > PLAY.
(Playback will begin.)
b PLAY : To begin from the forward side.
<@ PLAY : To begin from the reverse side.
elt i wnt ttt wu mit at nm
aban ite mS c |
To play back on Deck 1, In steps 2 and 5 above, press the but-
tons ( 2 and 5 ) for Deck 1.
To temporarily stop playback
(Deck 2 only)
PAUSE Press If PAUSE.
The “PLAY” indicator will flash.
To resume playback, press the play button cor-
tesponding to the side of the tape being
played.
To stop playback
ee Press Hi STOP.
e The “PLAY” indicator will switch off.
®