Technics RS-TR474 Operating Instructions

Please check and identify the supplied
accessories
we
; - acts i
Cl
AC
power
supply
Cord...
2.2...
eee
eee
eee
41
O
Stereo
connection
oO
Power
plug
adaptor......1
0
|
{For United (For Australia (For others) cables . (Not supplied for United H
Kingdom) and N.Z.) Kingdom, Europe, t
Austratia and NZ) H
t
SF os
ey
{(VJA0733) {RJA0036-K} (SJP521 3-2}
—
Before making connections, make sure that the power to this unit For United Kingdom only
and all other system components is turned off. BE SURE TO READ THE CAUTION FOR AC
Nolte J .
* Avoid letting the cables touch each other as much as possible, POWER SUPPLY CORD ON PAGE 3
otherwise noise will be generated. BEFORE THE FOLLOWING CONNEC.
* Although the figure below shows the AC power supply cord be- TIONS.
ing connected to a household AC outlet, if the amplifier (or
recelver) is equipped with an AC outlet, connect the cord to that
outlet. (For areas except United Kingdom, Europe, Austrafia
and N.Z.) i
Placement hints Set the voltage selector to the voltage setting for the area | t
It this unit is placed near a receiver or a tuner, a “hum” nolse in which the unit will be used. |
may be heard during tane playback, recording, ar AM reception [Use a minus (—) screwdriver]
of the receiver ar the tuner siote
if this occurs. leave as much space as possible between the if the power supply in your area is 117 ¥ or 120 V, set to
units, or place them where there is the least ammount of “hum”. the "127 V" position.
Note that this unit will be serious!y damaged if this setting
| is not made correctly.
Hf the power plug will not fit your socket,
Stereo connection cable use the power plug adaptor fincluded).
White (L) _ _. _—.. — -
Red (A) +Er
(For areas except Australlz and NZ) |
insertion of Connector H
Even when the connector is perfectly in- |
serted, depending on the type of infet used.
the front part of the connector may jut out |
| as shown in the drawing. t
This unit | However there is no problem using the unit |
Connector
[Kb 2
\ Aoprox 6mm
‘Appliance inlet i
{ Connect this cord after } |
Dp ; all other cables and
cords are connected
Voltage selector
(For areas except United Kingdom, Europe,
Austrafia and N.Z.)

Technics RS-TR474 Specifications

General

Track System	4-track, 2-channel stereo
Tape Speed	4.8 cm/s
Frequency Response	20Hz to 17kHz (Metal tape)
Type	Cassette Deck
Heads	1 x Record/Playback, 1 x Erase
Motor	DC motor
Output	400mV (Line)
Dimensions	430 x 125 x 290mm
Power Supply	220-240V AC, 50Hz