Technics RS-X102

| Rs-x102
Mi LOCATION OF CONTROLS
AUTO REVERSE recone marsax DECK 2
Controls common to both tape decks Indicators common to both tape decks
[4] DECK ON/OFF switch (DECK)
RC1 PLAY <@ PLAY RC2
[2] Synchro-start button (SYNCHRO START)
This button can be used to start a tape-to-tape recording,
simultaneously starting tape deck 1 (the playback deck) and
tape deck 2 (the recording deck).
[A] Input level meter
During playback, this meter indicates the level of the record-
ed sound source.
[3]
Tape-to-tape
recording
tape-speed
selector
During
recording,
it
indicates
the
level
being
recorded,
(TAPE
EDIT
SPEED)
adjusted
by
the
recording-level
control.
This selector can be used to select the recording speed
when a tape-to-tape recording is made.
Dolby noise-reduction indicator (DOLBY NR)
This indicator illuminates when the Dolby noise-reduction
[4]
Recording-level
contro!
(REC
LEVEL)
button
is
pressed.
This control can be used to regulate the recording level of
tape deck 2.
Reverse-mode indicators ( = , c> , o>)
One of these indicators illuminates to show which of the
reverse modes was selected by the reverse-mode selector.
[5] Reverse-mode selector (REVERSE MODE)
This selector can be used for selection of the reverse mode
(for either playback or recording).
[D] Edit-recording indicators
(EDIT MODE, CD, x1, x2)
The words “EDIT MODE” and “x1 (or "x 2”) indicator will
[6]
Dolby
noise-reduction
button
(DOLBY
NR)
illuminate
when
a
tape-to-tape
recording
is
made.
This
button
is
used
to
reduce
the
“hissing”
noise
heard
from
The
words
“EDIT
MODE”
and
“CD”
indicator
will
illuminate
the
tape.
when
a
CD
edit-recording
is
made.