Technics SA-AX540

Basic operations
SPEAKERS A,B
(CD CD)
A SPEAKERS B
jl^H For front speakers with an impedance under 8 Q
Press and hold [A] or [B] until “LOW IMP”
lights up on the display.
If even one of the speakers being used has an impedance under
8 Q, press and hold down either [A] or [B] for 4 seconds or more to
set the impedance on the main unit to LOW.
(Press and hold down once again for 4 seconds or more to turn it
off.)
Note that when “LOW IMP" is illuminated, SPEAKERS A and B
cannot both be used at the same time.
To change speakers:
e.g. To use SPEAKERS B, press [A] (“0” goes out), and then
press [B] to activate SPEAKERS B.
The TAPE (MONITOR) indicator
This indicator lights in the following two situations:
1. While TAPE is selected.
2. While TAPE MONITOR is in use.
To use the tape monitor
(For use when you have connected a graphic equalizer to the
TAPE terminals.)
If [TAPE MONITOR] is pressed while a source other than TAPE is
selected, the “TAPE (MONITOR)” indicator lights and the tape
monitor comes on.
Sources other than tape can be selected with [INPUT SELECTOR]
while the “TAPE (MONITOR)” indicator is on.
Press [TAPE MONITOR] again to turn the tape monitor off.
( ■ $ See “Making a recording" on page 32 for details on how to use
the tape monitor during recording.)