Technics SA-AX540

Enjoying sound modes
Ensure you have your speakers set up in the following way.
© The front speakers are connected to the A terminals { ■ ♦ page
12) and “SPEAKERS A" is selected. _
1 Turn [INPUT SELECTOR] to select the
source.
2 Turn the sound mode selector to
select the desired mode.
The selected reproduction mode appears on the display.
{* Page 20 for descriptions of the modes.)
3 (only if you select SFC in the above step)
Select the mode.
4 Start the source.
To turn off the Dolby Pro Logic or SFC functions
Turn the sound mode selector (®) to select “STEREO".
For your reference
You can set the sound mode for each source.
Each source will retain the selected mode.
These modes cannot be turned on while SPEAKERS B is on.
These modes are automatically switched to STEREO if
SPEAKERS B is selected or both speakers are turned off. When
SPEAKERS B is turned off or SPEAKERS A is selected, the mode
is switched back to the last mode.
While using the SFC modes
by remote control only
To adjust speaker level
© Press [LEVEL] to select the speaker channel to adjust.
The ou tput level appears on the display.
You can adjust center speaker volume only in THEATER mode
@ Press [-] or [+] to adjust the output level.
Channels C and S can be adjusted between -12 dB and +12
dB.
To adjust delay time
by remote control only
You can adjust the surround channel only.
© Press [DELAY].
When the button is pressed, the current delay time is
displayed.
® Press [-] or [+] to set the time.
Each press changes the delay time.
Increments depend on the mode.
Select a delay time setting to accommodate to your individual
needs.
SFC modes
Available delay time setting (ms)
HALL
20, 25, 30, 40 , 50
CLUB
0, 1 5 , 20, 25, 30
LIVE
15,20, 30,40,50
THEATER 15, 20,25, 30, 40
SIM SURR 15 . 20. 25. 30. 40
The figures in bold italics are the factory settings.
23
RQT5212
Sound
modes