Technics SA-AX540 User Manual

The procedures below are examples for when a TV and DVD player are connected to the receiver as shown in this manual.
Make sure the remote control is in the DVD player operation mode. Page 26.)
Actual operations depend on your equipment and software.
To watch DVDs
Point the remote
control toward the
TV and the receiver
TV <*>
o*o *
Point the remote control Point the remote control
toward the DVD player toward the TV
and receiver
DVD 6 TVMDEO
0*0 * O
Switch ON the
TV and the
receiver.
Switch ON the Set the TV/VIDEO jjj
DVD player. mode on the TV 1
to “VIDEO”, #
The receiver will
switch to DVD
input. Point the remote control
toward the DVD player.
►
O
Play will begin.
[DVD changer only]
To start play from the
desired disc
H _ 666
'—^ Select disc number.
within 3 seconds
To select the top
menu
— o _
o.O D* O
^ J Play will begin.
To use the DVD menu
MENU "alS"
0*0 C6* O
Play will begin.
DISPLAY
o i O C6
To use on-screen
graphic controls
(Graphic user interfaces,
GUI, are a feature of some
DVD players. See your
player’s manual for
details.)
I
O *00
□ or 6(66
Play will begin. 6066
To skip to the
beginning of a track or
chapter
o o
To stop play
■
CD
To switch OFF the TV
TV *
O ^ o
To switch OFF the DVD player
DVD <*>
o^o nm
Turn the receiver OFF last.
31
RQT5212
Remote
control

Technics SA-AX540 Specifications

General

Tuning Range	FM, MW
Damping Factor	30
Input Sensitivity	150mV (line)
Power Output	100W per channel (8 ohms, 20Hz-20kHz, 0.9% THD)
Impedance	8 ohms
Dimensions	430 x 158 x 370mm
Speaker Load Impedance	8Ω to 16Ω
Video Connections	Composite Video