Technics SA-EX500 - Technical Specifications.26

Technical spe<
cification s (DIN 45 500)
M AMPLIFIER SECTION
Total harmonic distortion
Power output (at 240 V)
MONO
0.2%
DIN 1 kHz (T.H.D. 1%)
2X100 W (8 £2)
STEREO
0.3%
20 Hz-20 kHz continuous power output both channels driven
S/N
2X90 W (8 £2)
MONO
60 dB (75 dB, !HF)
Total harmonic distortion STEREO
58 dB (71 dB, IHF)
rated power at 20 Hz-20 kHz
0.05% (8 Q)
Frequency response
20 Hz-15 kHz, +1 dB, -2 dB
half power at 1 kHz
0.03% (8 a) Alternate channel selectivity
Power output at the Dolby Pro Logic operation ±400 kHz
65 dB
DIN 1 kHz (T.H.D. 1%) Capture ratio
1 dB
Front
2X60 W (8 £2)
Image rejection at 98 MHz
40 dB
Center
60 W (8 £2)
IF rejection at 98 MHz
70 dB
Surround
60 W (8 £2) Spurious response rejection at 98 MHz 70 dB
Subwoofer [SA-EX7Q0 only]
60 W (8 a)
AM suppression
50 dB
Load impedance
Stereo separation
Front 1 kHz
40 dB
[SA-EX700] Carrier leak
AorB
8-16 a
19 kHz
-30 dB (-35 dB, IHF)
A and B
8-16 a
38 kHz
-50 dB (-55 dB, IHF)
[SA-EX500]
8-i6a
Channel balance (250 Hz-6.3 kHz)
±1.5 dB
Center
8-16 a
Llmittlng point
1.2 pv
Surround
4 - 1 6 a
Bandwidth
Subwoofer [SA-EX700 only]
8-i6a
IF amplifier
180 kHz
Intermodulatlon distortion
FM demodulator
1000 kHz
rated power at 60 H 2 :7 kHz=4:1, SMPTE 0.5% (8 £2)
Antenna terminal(s)
75 a (unbalanced)
Power bandwidth
both channels driven, -3 dB
10 Hz-40 kHz (8 a)
■ AM TUNER SECTION
Damping factor
30 (8 a)
Frequency range
Frequency response
AM
522-1611 kHz (9 kHz steps)
PHONO
RiAA standard curve
530-1620 kHz (10 kHz steps)
(30 Hz-15 kHz) ±0.8 dB
Sensitivity
[SA-EX700] CD, TAPE, VDP, TV, VCR 1,
VCR 2
AM
20 pV, 330 MV/m
10 Hz-40 kHz, ±3 dB
[SA-EX500] CD, TAPE, VCR 1, TV/VCR 2 10 Hz-40 kHz, ±3 dB
Input sensitivity and Impedance
PHONO 3 mV/47 kO
[SA-EX700] CD, TAPE, VDP, TV, VCR 1, VCR 2 200 mV/22 kfl
[SA-EX500] CD, TAPE, VCR 1, TV/VCR 2 200 mV/22 ka
S/N at rated power (8 a)
PHONO 70 dB (IHF, A: 80 dB)
[SA-EX700] CD, TAPE, VDP, TV, VCR 1, VCR 2
75 dB (IHF, A: 85 dB)
[SA-EX500] CD, TAPE, VCR 1, TV/VCR 2 75 dB (IHF, A: 85 dB)
Tone controls
BASS 50 Hz,+10 to-10 dB
TREBLE 20 kHz,+10 to-10 dB
Loudness control (volume at -30 dB) [SA-EX700 only]
50 Hz, +9 dB
Output voltage
VCR 1 OUT, TAPE REC (OUT) 200 mV
Channel balance (250 Hz-6.3 kHz) ±1 dB
Channel separation 55 dB
Headphones output level and impedance 430 mV/330 a
Subwoofer frequency response [SA-EX700 only] 7-100 Hz
3 mV/47 ka
200 mV/22 ka
200 mV/22 ka
75 dB (IHF, A: 85 dB)
50 Hz, +10 to -10 dB
20 kHz, +10 to -10 dB
Selectivity
AM (at 999 kHz)
Image rejection
AM (at 999 kHz)
IF rejection
AM (at 999 kHz)
■ VIDEO SECTION
Output voltage at 1 V Input (unbalanced)
Maximum input voltage
Input/output impedance
1 ±0.1 Vp-p
1.5 Vp-p
75 £2 (unbalanced)
■ GENERAL
Power supply
Power consumption
Dimensions (WX HX D)
Weight
AC 50 Hz, 230-240 V
[SA-EX700] 220 W
[SA-EX500] 205 W
[SA-EX700] 430X158X358 mm
[SA-EX500] 430X136 X358 mm
[SA-EX7003 10.3 kg
[SA-EX500] 9.3 kg
■ FM TUNER SECTION
Frequency range
Sensitivity
S/N 30 dB
S/N 26 dB
S/N 20 dB
IHF usable sensitivity
IHF 46 dB stereo quieting sensitivity
87.50-108.00 MHz
1.5 pV/75 £2
1.3 pV/75 £2
1.2 pV/75 £2
1.5 pV/75 £2 (IHF’58)
22 pV/75 £2
Notes:
1. Specifications are subject to change without notice.
Weight and dimensions are approximate.
2. Total harmonic distortion is measured by the digital spectrum
analyzer.
26