Technics SA-EX500 User Manual

Listening to radio broadcasts
Press V or A to tune to the
desired broadcast.
If either button is held down for an
instant until the frequency begins to
scroll, the broadcast stations can be
tuned in automatically when a broadcast
station is found.
Tuning may stop automatically if any
jamming is encountered.
Lights up when tuned
I Lights up when an FM stereo broadcast is received
GUAfVrZ LOCK STEREO
c n n
11 1
Qu " 1
OO >LJ MH*
Frequency display
Presetting radio stations into the memory channels of this unit
makes selecting stations easy and simple.
How many broadcast stations can be preset?
A total of 30 FM and AM stations can be preset.
How is presetting done?
The two following methods are available.
® Automatic memory presetting
Automatic memory presetting allows this unit to automatically
search for broadcast stations and then preset them into memory.
With this function, searching proceeds from the frequency cur¬
rently being displayed and continues to highest frequency, and
broadcast stations are preset in the order in which they are
located.
With this method, the channels that can be preset into the
memory are set as follows for different bands.
Channel
preset, the previous presettings in the sections in the above illus¬
tration which overlap will be erased and the subsequent settings
will be preset. Therefore, the FM band stations will be kept for
channels 1-20 and the AM band stations will be preset to chan¬
nels 21-30.
• Manual memory presetting
The desired broadcast stations can be preset into the desired
channels by the user.
This can also be used as a method for changing selected
broadcast stations that were preset in “Automatic memory pre¬
setting".
If a new broadcast station is preset into a channel, the setting
for the broadcast station which was previously entered In that
channel will be automatically erased.
If noise is excessive in the FM stereo mode
Press FM AUTO/MONO. (The “STEREO" indication will switch off.)
QUARTZ LOCK
l~ l\/l
1 1 !
MOP
QO 1
Cji_i, ii
iO
-
_/ MHt
Lights up
The broadcast will be monaural, but noise will be reduced. If the
button is pressed once more, the stereo mode will be resumed.
To change the AM frequency step
Press and hold BAND for about 3 seconds when AM band is select¬
ed.
(The frequency step changes to 10 kHz per step.)
To return to the previous step, press and hold BAND for about 3
seconds again.
14

Technics SA-EX500 Specifications

General

Brand	Technics
Model	SA-EX500
Category	Stereo Receiver
Language	English