Technics SA-GX505 User Manual

Standard
Operations
1 2
Headphones
(not included)
Plug type:
6.3 mm phone
plug stereo type
1 Switch ON the power.
Select the “A” and/or “B” speaker system(s)
to be used.
Select the audio or video source.
VCR
1:
Press
this
button
to
watch
video
tapes
from
the
VCR
connected
to
the
“VCR
1”
terminals.
VCR
2:
Press
this
button
to
watch
video
tapes
from
the
VCR
or
video
discs
from
the
video
disc
player
con-
nected
to
the
“VCR
2”
terminals.
TAPE/DAT MONITOR: Press this button to listen to tape or
digital
audio
tape
connected
to
the
“TAPE/DAT”
terminals.
No other sources selected by the input selector can be
heard while the tape indicator is illuminated. To listen to
some
other
source,
press
this
button
once
again.
CD:
Press
this
button
to
listen
to
compact
discs.
TUNER:
Press
this
button
to
listen
to
radio
broadcasts.
PHONO: Press this button to listen to phono discs.
Note: ;
It
is
recommended
that
the
power
to
the
compact
disc
player should be switched OFF when it is not being used.
A Start the audio or video source.
(Refer to the appropriate operating instructions for details).
5 Adjust the volume level.
While listening to music
[LOUDNEsS|
Set to “ON” position when listening at low
volume level.
(The loudness indicator will illuminate.)
Adjust
the
left/right
volume
balance.
The
left/right
volume
balance
of
the
rear
speaker
systems
cannot
be
adjusted.
Tape indicator
Loudness indicator
=445
LOUDNESS || BALANCE
To listen to a desired audio source
while watching video picture
| Follow steps 1~2 at the left.
Select the desired video source and audio
source in step 3 at the left.
Be sure to select the video source first.
Start the video and audio source.
When listening through headphones
Use the volume control to reduce. the volume level, and con-
nect the headphones to the headphones jack.
® If sound from the speakers is not wanted, set the speaker selec-
tors (“SPEAKERS”) to the “OFF” position.
¢ Set the Dolby 3 stereo ON/OFF button and Dolby Pro-Logic Sur-
round ON/OFF button to OFF when the center speaker and/or
rear speakers are connected.
¢ Avoid listening for prolonged periods of time to prevent hearing
damage.
After use
Be sure to reduce the volume level, and switch the power to
standby mode from the remote-control transmitter or by the
power “ d STANDBY/ON” switch of this unit.
Note:
The input selection and the muting settings will be retained (as
they were at the time when the power was switched to standby
mode) by the memory back-up function.

Technics SA-GX505 Specifications

General

Brand	Technics
Model	SA-GX505
Category	Stereo Receiver
Language	English