Technics SA-GX505

Using the Dolby 3
1 2 3 46
Adjustment of each channel balance
1 Switch ON the power.
Select the “A” and/or “B” speaker system(s)
to be used.
Turn on the Dolby 3 stereo system.
(The Dolby 3 stereo indicator will ituminate.)
Dolby 3 stereo indicator
(Hz) 40 63 100 180 250 460 630 tk 16k 25k 4k 63k 10k 125k 16k
anes FM STEREO Ct Cy (rt CENTER
ct re ng 0
Press the test signal button.
Test signal sounds sequentially as follows:
Front speaker (left) + Center speaker
t Be etl
Front speaker (right)
Adjust the volume balance.
While standing in the listening area, adjust the output level
of center speaker until they are all identical.
V: Decrease the output level.
A: Increase the output level.
Stop the test signal.
Enjoying Dolby 3 stereo sound
Start the sound source.
(Refer to page 14.)
Turn on the Dolby 3 stereo system.
(The Dolby 3 stereo indicator will illuminate.)
Dolby 3 stereo indicator
-10
(Hz) 40 63 100 160 250 400 630 1k t6k 25k 4k 83k {0k 125k {6k
air ae miro ri
ss o FM STEREO fa £1. { Lt id ic