Technics SA-GX505 - Remote-Control Operation; Tuner and CD Player Controls

Remote-Conitrol
Operation
e
This
remote-control
transmitter
can
be
used
for
contro!
of
a
Technics
cassette
tape
deck
or
a
compact
disc
player
with
a
remote-control
terminal.
Consult your dealer for details.
eFor
detailed
information
concerning
operation
steps,
etc.,
please
refer
to
the
appropriate
page
for
each
unit
and
the
respective
operating
instructions.
¢
For
this
system,
you
can
listen
to
tapes
or
compact
discs,
etc.,
,
by
operating
the
remote-control
transmitter
without
using
this
unit’s
input
selectors.
¢
Make
sure
that
the
power
of
each
unit
is
set
to
the
“ON”
posi-
tion,
before
beginning
the
operations.
PPLAY MESTOP FIPAUSE isd) PAO
NTINUE Ficlt
f
— 32 —
EMG Tuner controis _
Press this button first to use the “OFF/ON” button or the [4] —
[0] buttons.
This button can be used for ON and OFF switching of this unit.
When switching the power ON and OFF, be sure to first press the
“TUNER” button.
[4] - [0]
Press these buttons to select the desired preset channel.
When these buttons are used, be sure to first press the “TUNER”
button.
To designate channels 1—9:
Press the appropriate (1 —9) preset-tuning button.
To designate channels 10—30:
@ Press the button for the most significant digit (1, 2 or 3).
@ Press the button for the least significant digit (1 — 0) within 2
seconds after pressing the first button.
Note:
If the interval between pressing the first button and pressing the
second button is more than about 2 seconds, the setting may not
be made correctly. If this happens, make the setting once again.
‘Compact disc player controls
[1] - buttons.
Press this button first to use the
mH -
Press these buttons to select the desired track.
Playback begins from the track selected.
When these buttons are used, be sure to first press the “CD”
button. :
Tracks 1~9:
Press the appropriate numeric button b = fo) directly.
To select a two-digit track number over 10:
Press the cs button the necessary number of time to select the
“tens” digit, and then one of the ¢, — & buttons to select the
“units” digit.
PLAY
Press this button to start play.
E
t
ress this button to stop play.
a
Press this button to temporarily stop play.
Press the play button to resume play.
E
lf a Technics multi compact-disc player is used in combination
with this unit, the disc to be played can be selected by first press-
ing this button and then pressing the appropriate numeric button
(d-4):
Press to select the desired play mode.
(“PROGRAM” or “CONTINUE”)
a
Press one of these buttons briefly to move the pick-up to the
beginning of a specific track.
Note:
When operating a compact disc player with a remote-control sen-
sor, face this remote-control transmitter toward the remote-con-
trol sensor of the compact disc player.