SHIFT
MIX 2CH
A
Î DIGITAL
Enjoying surround sound
DOLBY DIGITAL
Play a DVD encoded with Dolby Digital.
[A] “ëDIGITAL” appears on the tuner/amplifier.
[B] To down-mix Dolby Digital (5.1ch) signals to 2 chan-
nels
Press [SHIFT] i [MIX 2CH].
To cancel
Press [SHIFT] i [MIX 2CH] again.
»
C
Speaker level adjustments
Remote control only
If the level of the speakers appears to be different while listening to a
source, adjust the levels of the speakers to the same apparent level.
1 Press [SHIFT] i [TEST] to output a test signal.
A test signal is output from the speakers in the following order.
Lch: Front left speaker
Cch: Center speaker
Rch: Front right speaker
RSch: Right surround speaker
LSch: Left surround speaker
(No signal is output for the subwoofer.)
2 Press [VOLUME (` or _)] to set the volume level of the front
speakers normally used for enjoying the source.
3 While the speaker to be adjusted is outputting a signal
Press [3] (to increase the level) or [4] (to decrease the level).
The level of the speaker changes.
Repeat step 3 as desired.
To stop the test signal
Press [SHIFT] + [TEST] again.
To adjust the levels during play
1 Press [CH SELECT] to select the speaker.
Each time you press the button:
Lch>Cch>Rch>RSch>LSch>SWch
^---------------------------------------------------------------}
SWch: Subwoofer (Adjust only when connected)
2 Press [3] or [4] to adjust the level.
Repeat steps 1 and 2 as desired.
To Next Page
Loading...