Technics SC-HD81 - Program Play (SC-HD81)

Cassette deck operations
wma
Program play
by remote conirol only
This function allows you to program up to 24 tracks,
El Press CD.
|
2. Press PROGRAM.
3 Press DISC.
(within 10 seconds or so)
Press DISC 1-5, whichever disc you want.
Press the numeric button(s) to select the track
you wani to play in the desired sequence.
To select a two-digit track:
Press 210 and then the two numbers you want.
Repeat steps 3 through 5 until you have pro-
grammed aii the iracks you wani.
Press >.
Play will start in the programmed sequence.
When all the programmed tracks have been played, the changer
will stop automatically.
To cancel program play mode:
Press PROGRAM.
“CLEAR” will appear on the display for approximately 1 second and
all the programmed tracks will be cancelled.
When “FULL” appears:
The number of programmed tracks is limited to 2-4. No further tracks
can be programmed.
When “—~—:-——” appears:
The total playing time of the programmed tracks has exceeded
99 minutes 59 seconds, or you tried programming track number 25 or
more, or you tried programming a disc not in playing position. In any
case, you can still program and play discs.
You can do the following during program play.
®Check program contents.
Press <4 and pp} while play is stopped. Every time you press
one of the buttons, the track and program No. are shown on the
display.
@Add to the program.
Repeats steps 3 through 5.
®Cancel entries.
A specific track only:
@ Press CANCEL. “CANCEL” will light.
@) Press the numeric button(s) of the track you want to cancel, or
press <q or P| to select the track you want to cancel and then
press CANCEL.
@) Press CANCEL once again. “CANCEL” goes out.
All tracks:
Press PROGRAM, or press ll while play is stopped.