Technics SL-1200GLDE - Page 40

arise some errors in the voltage values and waveforms depending
upon the internal impedance of the tester or the measuring unit.
No mark: Voltage when at a stop
( ):Voltage during rotation
- Signal line
- : +B line
- Important safety notice: / Components identified by mark have
special characteristics important for safety. When replacing any of
these components, use only manufacture’s specified parts.
- This schematic diagram may be modified at any time with the
development of new technology.
10.2. Schematic Diagram
11. Printed Circuit Board Diagram
12. Block Diagram
13. Wiring Connection Diagram
14. Replacement Parts List
Note:
- All parts are supplied by SPC .
- Important safety notice:
- Components identified by mark have special characteristics
important for safety.
- Furthermore, special parts which have purposes of fireretardant
(resistors), high-quality sound (capacitors), low-noise (resistors),
etc. are used.
- When replacing any of components, be sure to use only
manufacture’s specified parts shown in the parts list.
- The parenthesized indications in the Remarks columns specify the
areas. / Parts without these indications can be used for all areas.
- (E): SL-1210M5GE
- (EB): SL-1210M5GEB
- (GN): SL-1210M5GGN
- (PP): SL-1210M5GPP
22