To Next PageTo Next Page
Need help?Do you have a question about the Technics SL-1210G and is the answer not in the manual?
General| Drive Type | Direct Drive |
|---|---|
| Motor | Coreless Direct Drive Motor |
| Wow and Flutter | 0.025% (W RMS) |
| Tonearm Effective Length | 230 mm |
| Tonearm Overhang | 15 mm |
| Cartridge | Not included |
| Speed Settings | 33 1/3, 45 RPM |
| Platter Material | Aluminum |
| Tonearm Type | Static Balance |
| Power Supply | AC120 V, 60 Hz |
Covers reading instructions, water use, cleaning, ventilation, heat sources, and plug safety.
Avoids flames, confined spaces, and ensures proper ventilation for the unit and placement.
Protects against fire, shock, and damage from liquids, unauthorized access, or self-repair.
Balance the tone arm by turning the balance weight until it is approximately horizontal.
Set stylus pressure control to '0' and adjust balance weight for proper stylus force.
Turn the balance weight to set the appropriate stylus pressure for the cartridge.
Adjust the arm height using the control ring to make the tone arm parallel to the record.
Check and adjust the armlift height for proper stylus placement and retrieval.
Adjust the anti-skating control to match the stylus pressure setting for balanced tracking.
Select auto or manual mode to adjust startup speed and brake speed using control knobs.
Turn the unit on, check the strobo light, and ensure 33-1/3 r/min is selected.
Press the START-STOP button to initiate the turntable's rotation.
Press RESET to activate the blue LED indicator for pitch control adjustments.
Lift cue lever to move arm over record, lower to start playback, lift to temporarily stop.
