Technics SL-D202 - Safety Suggestions; Specifications

Suggestions for safety
Before using this unit, be sure to read applicable items of the
operating instructions and these safety suggestions carefully;
and afterwards keep them handy for future reference. Take
special care to follow the warnings indicated on the unit itself as
well as in the operating instructions.
1. Avoid places where there is water or humidity.
Do not use this unit near a bathtub, washbasin, swimming
pool, or the like. Damp basements should also be avoided.
2. Do not allow water or any foreign object to get inside this
unit.
Do not place small metal objects or anything containing
liquid on or near the unit.
3. Avoid placement of the unit where it will be exposed to the
direct rays of the sun, or where ventilation is inadequate.
Do not place this unit in a bookcase or between cabinets,
unless proper ventilation is provided, or where curtains or
furniture may obstruct the ventilation holes.
4. Place this unit away from heat-emitting appliances.
Never place this unit on or near a radiator, heat register,
stove, or any other heat-emitting equipment (including
amplifiers).
5. Placement
Place the unit ona stable, vibration-free, level shelf or stand.
6. Use of a cart or stand.
When deciding on a cart or stand, be sure to use only with
the cart or stand recommended by the manufacturer.
7. Wall or ceiling installation.
If the unit is to be mounted on a wallorceiling, be sure to do
So only as recommended by the manufacturer.
8. Check the voltage rating of this unit before connecting the
unit to a power source.
Be sure to connect the unit only to the type of power source
indicated in the operating instructions, or as indicated on
the unit itself.
9. Care of the power cord and plug.
Take care that the cord is not bent sharply (especially near
its Connection to the unit or near the plug), that nothing is
placed on it, and that it is not pinched, crushed or frayed.
Never take hold of the plug or cord if your hand is wet, and
always be sure to grasp the plug body when connecting or
disconnecting it.
10. If the unit wilt not be used for an extended period of time:
Be sure to disconnect the power cord from the wall outlet.
11. Maintenance
Refer to the operating instructions for details.
12. Never attempt repairs yourself:
(a) If the power cord or plug is damaged.
(b) Ifa foreign object has fallen or liquid has spilled into it.
(c) If the unit is exposed to rain.
(d) If the unit does not function normally, or if operation
shows a distinct change in performance.
(e) Ifthe unit has been dropped and the cabinet or chassis
are damaged...etc.
Unplug the power cord and have it checked by a qualified
technician (or the dealer from whom the unit was purchased
Or the nearest servicenter).
13. Repairs
Except for adjustments explained in the operating instruc-
tions, do not attempt any repairs yourself. Be sure to re-
quest service from a qualified technician (or your dealer or
nearest servicenter).
Specifications
@ General
Power supply: ~110-120/220-240 V. 50 or 60 Hz
Power consumption: 7W
Dimensions:
43
X
10.6
X
37.5
cm
(WXHXD) (16-15/16" X 4-7/32" x 14-3/4”)
Maximum height when top
(dust cover) is open.
43 X 37 X 42 cm
(16-15/16" X 14-9/16" X 16-17/32")
Weight: 6 kg (13.2 Ib.)
Turntable section
Type: Direct drive
Automatic turntable
Auto return, Auto stop
Drive method: Direct drive
Motor: Brushless DC motor
Drive control method: —F G servo control
Turntable platter: Aluminum die-cast
Diameter 31.2 cm (12-9/32 inches)
Turntable speeds: 33-1/3 rpm and 45 rpm
Pitch control: 10% adjustment range
Wow and flutter: 0.012% WRMS*
0.025% WRMS (JIS C5521)
+0.035% peak
(IEC 98A Weighted)
“This rating refers to turntable assembly alone, excluding
effects of record, cartridge or tonearm, but including
platter. Measured by obtaining signal from built-in fre-
quency generator of motor assembly.
Rumble: ~56 dB (IEC 98A Unweighted)
~78 dB (IEC 98A Weighted)
Tonearm section
Type: Universal tonearm
“S” shaped tubular arm
Static balanced type
Effective length: 230 mm (9-1/16”)
Overhang 15 mm (19/32")
Tracking error angle: Within 2°32' at the outer groove
of 30 cm (12”) record
Within 0°32’ at the inner groove
of 30 cm (12”) record
Offset angle: 22°
Friction: Less than 7 mg (lateral, vertical)
Effective mass: 11g (without cartridge)
Applicable cartridge
weight range: See page 6.
Stylus pressure
adjustment range: 0—2.5g
Headshell weight: 7.59