You can program up to 32 seleclions horn the five discs in any
order as you desire.
3 251
nnnnnnnnnnr_
;"_'.',M.oDEtin",',esio_modei.................
1_ Press PROGRAM MODE
SO
_"") that the "PGM" indicator
illuminates.
Each time the button is pressed, the
display will change in the following
order:
PGM --, DEL --, (off).
t I
Press the desired disc but-
ton (1 - 5).
0,s_,_=__=_ =so, _ For example:
O O O 0 0 TO select disca, press DISC 3,
I
t ._, 4_01
.,,:)(_ , lL,,=,._,'
Specified disc number
The "AL" indication shows that all the tracks
on the disc are selected.
To program by means of disc numbers only,
repeat the above operation. (The count wJll in-
crease by one for each operation.)
i ................,,,;,;,;,;,,',,,ic'b.tio,is)
...... to specify the track number
I'--Ir---I _[_lr--1 For example:
To select track number 20, press
>10, then 2, and then O.
I
completed the desired entry.
If you enter non-existing disc(s) or track(s) soon after
the loading drawer is closed or when it is open, the
corresponding indicator illuminates and the entry is
included in the count. In the play mode, the changer
will cancel the non-existing entry.
I I -_Ii-l
If you attempt a 33rd selection, the "- F" (full) indica-
tion will be displayed.
i " .....'r.'"=;"O';..,'i,. .......
To enter additional selections during
'_ play, repeat steps 2 and 3.
_--7-"' '-'"-''
,_,.,_,,
To clear the entire programmed contents
[In the stop mode]
Press II.
The display will indicate as below.
I I I _q n
O,SC /__lm_ No I_1
To cancel program mode
PROGRAM MODE
[In the stop mode]
Press PROGRAM MODE twice.
The changer will return to sequential play
mode.
The programmed contents will remain stored in the memory until
they are cleared, even after the program mode is canceled.
Therefore, after using program play, it is possible to cancel the
program mode and use another play mode (except delete play)
and then still use the same program play again at a later time.
In addition, if the disc is replaced with another one, program play
will be carried out using the new disc. If non-existing entries oc-
cur at this time, they will be canceled.
For your reference:
The program mode and the programmed contents will remain
stored in the memory even after the unit is switched off.
However, if the power cord is unplugged or the power supply is
otherwise interrupted for an extended length of time, the con-
tents of the memory will be erased.
9
To Next Page
Loading...
