Technics SU-G95

Locate the nipper to the F IZ,
thin portion of the joint. 4
Cut the joint.
Bottom chassis
ass’y
2. After cutting the joints(6 portions), bend the portions of the
1.
Cut
the
joints(6
portions)
between
bottom
cover
and
bottom
chassis
ass’y
in
the
direction
of
arrow
with
pliers.
bottom
chassis
ass’y
with
nipper.
Unsolder the terminals of power IC
or regulator transistor
—— CAUTION
e After replacing the power IC or regulator transistor, apply
a sufficient quantity of compound grease (RFKX0002)
between the heat sink and the power IC or regulator
transistor.(Radiation of power IC & transistor)
e Tighten enough the screws( @~ @) after replacing the
power IC or regulator transistor.
Otherwise, the heat radiation works little.
Muting P.C.B.
3. When replacing the power IC or regulator transistor,
unsolder
the
terminals
of
power
IC
or
regulator
transistor
on the soldered surface.
¢ Release the 2 claws of muting P.C.B. and remove it
because of using the long screwdriver to tighten the
screw firmly.
Transistor
holders
4. Then remove the 6 screws( @ ~ @) fixed to the power IC
5.
After
replacing
the
power
IC
or
regulator
transistor,
upset
or
transistor
holders.
the
bottom
cover
and
align
the
ribs
of
the
bottom
cover
to
the
lugs
on
the
bottom
chassis
ass’y.
|
6.
After
mounting
the
bottom
cover
on
the
bottom
chassis
ass’y,
fix it
with
a
screw(XTB3+8).
|
.f
— FJ—