Before leaving
When the installation is complete, always check for gas leaks
using a soapy solution.
Never use a flame to make this check.
Ignite all burners on high flame to ensure correct operation of gas
valves, burners and ignition.
Turn gas taps to low flame position
and observe each burner to ensure they ignite completely at all
ports and that the flame is stable.
Conduct these checks for each
burner individually and concurrently.
When satisfied with the hotplate, instruct the user on the correct
method of operation.
If the appliance fails to operate correctly after
all checks have been carried out, call the
Glen Dimplex Service Centre.
Installation
19
To Next Page
Loading...
