Doc No: OMM50001243
Rev: C Page 43 of 68
This document and all the information contained herei
n are the confidential and exclusive property of TechnipFMC,
and may not be reproduced, disclosed, or made public in
any manner prior to express written authorization by TechnipFMC.
10.3.2.2 Valve Removal Tools
There are two (2) Knock Out tools available for removing valves from M06 series
pumps. The P534695 Small Ball Knock Out tool is the preferred tool for disc valve
removal. The P504436 Knock Out tool can also be used in the M06 pump models.
Figure 15: Illustration for the Ball Knock Out Tool
The suction valve is removed first.
All Knock Out tools are used in a similar manner to the P504436 tool shown in section
10.3.1.2. The ball type tool is used with the ball end positioned against the bottom of
the valve seat.
To Next Page
Loading...