TechniSat DIGIPLUS UHD S

126
Up arrow key Move picture up (only when picture height has been
enlarged)
Down arrow key
Move picture down (only when picture height has been
enlarged)
OK buon
Scroll through zoom levels
Le arrow key Reset user-defined format seing
> To hide the format switching screen, press the Back buon.
11.13 PiP / PaP function
Your device is equipped with both the PiP function (PiP = Picture in Picture), and the
PaP function (PaP = Picture and Picture). You can set which display you prefer under
Menu > Seings > Image seings > PiP / PaP mode.
See also the PiP / PaP section of the instruction manual.
The PiP / PaP function is not available for UHD broadcasters.
11.13.1 Calling up the PiP / PaP function
> Press the PiP / PaP buon to switch on the PiP or the PaP function.
11.13.2 Swapping PiP / PaP pictures
> Press the Back buon to toggle between the pictures. This toggles between
PiP / PaP and the main picture.
11.13.3 Exiting the PiP / PaP function
> You can exit the PiP or the PaP function both by pressing the PiP / PaP
buon and by pressing the TV/Radio buon.
11.14 Sleep timer
You can set the switch-o time of your TV using the sleep timer.
> You can set the sleep timer by pressing the Sleep timer buon a number of
times (15 minutes to 120 minutes), or switch it o.
Aer reaching the set time, the DIGIPLUS UHD S automatically switches to
standby mode.
Due to the new Europe-wide energy saving regulations, the device
automatically switches to standby if no operation has been carried out for 3
hours. This function can be configured under Menu> Seings > Basic seings
> Auto standby.