TechniSat DIGITRADIO 306 User Manual

- 6 -

DAB Operation

Press the MODE button repeatedly to select DAB. The unit will enter DAB mode and perform the
auto scan function. During the scan the display will show “Scanning… ” together with a slide bar that
indicates the progress of the scan and the amount of stations that have been found so far. Once the
scan has finished, the unit will select the first alpha numerically found station.
To explore the found stations, turn the VOLUME/SELECT Knob to select and press the same knob to
confirm.

Station List
1. During DAB mode, press the TUNE button to enter Station list.
2. Turn the VOLUME/SELECT Knob to explore the found DAB+ stations and then press the same
knob to confirm.

Full scan
Press and hold MENU/INFO button, and then turn the VOLUME/SELECT Knob to select Full scan.
Press the same knob to confirm.
1. The display will sh
ow “Scanning…” and a progress slide bar.
2. All the stations that have been found will be stored automatically. To explore and listen to the
found stations, turn the VOLUME/SELECT Knob to select and press the same knob to confirm.


Manual tune
As well as the full scan function, you can manually tune the receiver. This can help you when aligning
your aerial or when adding stations that were missed while auto tuning.
1. Press and hold MENU/INFO button.
2. Turn the VOLUME/SELECT Knob to select “Manual tune”, and press the same knob to confirm.
3. The display will show the multiplex 5A to 13F.
4. Turn the VOLUME/SELECT Knob to select the channel, and press the same knob to confirm.

DAB Display Modes
Every time you press the MENU/INFO button, the display will show the following display modes:
DLS – Signal Strength – Programme Type – Ensemble – Frequency – Signal error – Bit Rate –
Time – Date

Prune Invalid
You may remove all unavailable stations from the list.
1. During DAB mode, press and hold the MENU/INFO button and turn the VOLUME/SELECT Knob
to select Prune and Press Same knob to confirm.
2. Turn the VOLUME/SELECT Knob to select <YES> and press the same knob to confirm or select
<NO> to cancel.

Preset Stations
This function allows up to 10 stations to be programmed into the memory and stored in both DAB
and FM mode.
1. Select your desired station, press and hold the PRESET button until the display shows "Preset
Store <#: (Empty) >".

TechniSat DIGITRADIO 306 Specifications

Power

rated voltage	AC 100-240V ~50/60Hz
adaptor output	DC 9V 1.6A
power consumption	14.5W

Audio

audio output	1 X 5W RMS
frequency range DAB	174-240MHz
frequency range FM	87.5-108MHz

Weight and Dimensions

unit dimension	221 mm (W) x 159 mm (D) x 137 mm (H)
weight	~1.3 kg