2. Turn the VOLUME/SELECT Knob to select preset number and press the same knob to confirm.
Recalling a Stored Station
1. To select a preset, press the PRESET button, and then turn the VOLUME/SELECT Knob to select
one of the listed preset stations.
2. Press the same knob to confirm the selection.
Operation of Preset and Recall stations are same for DAB and FM.
FM Operation
Switching from DAB to FM Mode
To switch the unit to FM mode, press the MODE button repeatedly to switch to FM mode. The display
will show the frequency.
Auto Scan
1. During FM mode, press the TUNE button to enter <Tuning>.
2. If briefly turn the knob at clockwise, Press the Volume/Select knob it will auto search up.
3. If briefly turn the knob at counter clockwise, Press the Volume/Select knob it auto search down.
4. Once a station has been found, the scanning will stop automatically.
The search may not stop at a station with a very week signal.
Manual Tuning
To search for FM stations manually, press the TUNE button to enter <Tuning>, and turn the
VOLUME/SELECT Knob until your desired frequency is reached.
With FM radio, it may be necessary to fine tune each station by turning the Volume
+/- dial repeatedly. Each turn will adjust the frequency by 0.05 MHz. If reception
is still poor, adjust the position of the aerial or try moving the radio to another
location.
FM Display Modes
Every time you press the MENU/INFO button, the display will show the following display modes:
Radio Text - Programme Type - Frequency - Audio Type - Time - Date
Scan setting
1. Press and hold the MENU/INFO button to access FM menu.
2. Turn the VOLUME/SELECT Knob to select “Scan setting” and then press the same knob to
confirm.
3.
Turn the VOLUME/SELECT Knob to select “Strong stations only” or “All stations” and then press
the same knob to confirm.