TechniSat DIGITRADIO 650

74
16.6 Repeat function
You can select whether a track, the entire folder/album (only for MP3-CDs) or all of
the tracks on the CD are to be repeated.
> Press the Repeat buon several times.
The selected mode appears on the display using an icon (Repeat Track,
Repeat Album, Repeat All, Shue).
> To switch the function o again, press the Repeat track buon as oen as
required until the icon no longer appears.
> Press the Shue buon to play the tracks in a random sequence.
16.7 Programming playback
You can programme up to 20 tracks on a CD in any sequence.
> Stop any playback in progress by pressing the STOP buon .
> Press the FAV buon on the remote control to access the programming
mode.
The display now shows [P01] for the first track to be programmed.
> Using the / buons, select a track and press the OK buon to accept
the storing.
> Then [PO2] is displayed for the second track which you can also add as
described above.
> When programming is complete, press the Playback/Pause buon to play.
To delete programming, either press Stop 2x or open the CD tray using
the Eject buon.
17 Audio input
You can play sound on an external device via the DIGITRADIO 650 speaker.
> Connect the external device to the AUX-IN port (15, 3.5 mm stereo jack) on
the back of the DIGITRADIO 650.
Alternatively:
> Connect the external device using the LINE-IN connection (14, stereo RCA
cable R/L) on the back of the DIGITRADIO 650.
> Use the MODE buon to select the AUX-IN or LINE-IN audio input, depending
on which port the external device has been connected to. [Aux-In] or [Line-
In] appears on the display.
The playback is controlled on the external device. Do not set the volume too
low to prevent interference.