Connecting to the Internet
> In order to use the Internet-based functions on your device there must be
an active connection to the Internet. Select on, to allow connection to the
Internet. In order to take full advantage of the TechniSat additional services
corresponding to your receiver, you must also agree to the data protection
stipulations in the window which then appears.
If you do not wish to use Internet functionality, select Internet > no. If you
want to use Internet services, the device will recommend allowing connection
to the Internet and accepting the Data Protection Declaration.
The connection to the Internet and the Data Protection Declaration can be
subsequently changed at any time from the main menu.
The functions described in this quick start manual and the user manual
assume that the Internet connection is enabled and the Data Protection
Declaration has been accepted.
Not all the services which are listed in the Data Protection Declaration are
necessarily supported by the device.
To Next Page
Loading...
