TechniSat TECHNISTAR S6

29
EN
Exiting the installation wizard
Confirm the final message from the installation assistant by pressing theOK buon.
6 Operation
6.1 Switching on
> Switch the digital receiver on by pressing the On/Standby buon either on
the device or on the remote control.
6.2 O
> Press the On/Standby buon either on the device or on the remote control to
switch the device o again.
> The device is now in ready mode (standby). This means that the time is
displayed on the device display panel (if activated). If the time is not shown,
the device has not yet read it. To do this, switch the device on and set it to
receive e.g. ZDF for approx. 30 seconds to automatically read the time.
6.3 Selecting a channel
6.3.1 Using the channel up/down buons
> Use theup/down arrow buons on the receiver to select a channel, or use
theChannel +/-buons on the remote control to scroll up or down the
channel seings.