TechniSat TECHNISTAR S6

53
EN
14 Soware update via USB interface
You have the option of updating the receiver's soware via the USB interface.
To be able to run the soware update via the USB interface, you first need to
download the current soware version from the Technisat Homepage (www.
technisat.de).
The update can be performed using a standard USB flash stick which has
been formaed in the FAT32 format.
> Now copy the soware file onto the USB flash stick.
> If you only want to run a single update, copy thesingleupdatefile or, for
multiple updates, the autoupdate file to the USB stick.
Please bear in mind that the singleupdate or autoupdate files may not have
a file extension. Please also note that, to do this, the folder seings on your PC
must be set to hide file extensions.
Do not store multiple soware files on the USB stick. Furthermore, the
"autoupdate" and "singleupdate" files must not be present at the same time.
> Now switch the receiver to standby and insert the USB stick into the receiver's
USB port. Now switch the receiver on.
The update process is now displayed in the following steps.
- The message Loading soware from data medium will now appear
- Then a progress bar appears showing the progress of the soware loading
operation.
> When the update is complete, the TV picture appears again. You can now
switch the receiver to standby and remove the USB stick.
The update should not be interrupted at any point by removing the USB
stick or by switching o the power supply, as this can cause the receiver to
malfunction.