TechniSat TECHNISTAR S6

52
EN
Throughout the time that the volume is switched to mute, the symbol
appears at the upper right of the screen.
13.5 Teletext (ISI mode)
Your device can display Teletext information on channels that broadcast Teletext data.
13.5.1 Switching on Teletext
> Switch the Teletext on by pressing the TEXT buon.
13.5.2 Page selection
> Use the number buons 0 to 9 to enter the 3-digit page number of the
Teletext page you want.
Your entry will be displayed in the upper le-hand corner of the screen.
As the Teletext pages cannot all be transmied by the broadcaster at the
same time, it may take a few seconds before the page is displayed. This is the
case when the requested page cannot be instantly read into the memory, e.g.
when using the Teletext search immediately aer the channel is changed.
13.5.3 Teletext subpages
If Teletext subpages exist for a selected Teletext page, the subpages already loaded
are indicated on the le, alongside the Teletext display. As soon as a new subpage is
available, this is automatically displayed.
> Use the OK buon to show a specific subpage.The column on the le side
of the screen is enabled. Subpages that have already been acquired are
displayed.
> Use the up/down arrow buons to select the desired subpage.
> You can exit the display of specific subpages by pressing OK.
13.5.4 Mixed mode
> Pressing the Teletext buon again enables mixed viewing mode. This means
that the Teletext is superimposed on the TV picture.
13.5.5 Exiting Teletext
> Pressing the Teletext buon takes you back to normal mode.