TechniSat TECHNISTAR S6

51
EN
> You can now highlight the desired channel using the up/down arrow buons,
the page up/down buons and the number buons.
> Press the OK buon to select the highlighted channel.
13.3 Switching between TV/Radio
> Using the 0 buon, retrieve the NAV menu.
> Now you can use the up/down arrow buons to highlight the desired
operating mode TV or Radio or Back to exit the menu again.
> Pressing the OK buon confirms the selection and switches to the selected
operating mode.
The unit switches to the last radio channel set.
13.4 Volume control (ISI mode)
You have the option of adjusting the volume on your digital receiver. This facilitates
operation of the receiver, as it means you can access all the major functions on a
single remote control, and will only rarely have to resort to using the remote control
for the TV.
> To adjust the volume of your TV, press the Volume + rocker to increase the
volume, and the Volume - rocker to decrease it.
During volume adjustment, the currently set volume is displayed at the upper
edge of the screen.
When you switch on the digital receiver, sound will be reproduced at the
volume level last set.
Volume control and the mute buon also control the digital audio outputs (not
for the bit stream seing) and switch these to mute.
13.4.1 Mute function
> By pressing the MUTE buon the sound is switched o or, if pressed again,
switched back on.