TechniSat TECHNISTAR S6

50
EN
13.1 Switching the device on/o (ISI mode)
> When the device is on standby, you can switch it on by pressing theOn/
Standbybuon on the remote control or on the device.
> When operating normally you can switch the device to standby mode by
pressing the On/Standby buon.
13.2 Channel selection (ISI mode)
13.2.1 Using the channel up/down buons
> Use theup/down arrow buons on the receiver to select a channel, or use
theChannel +/-buons on the remote control to scroll up or down the
channel seings.
13.2.2 Using the number buons
> Use the number buons to enter the number of the desired channel.
Example:
1 for channel slot 1
1, then 4 for channel slot 14
2, then 3, then 4 for channel slot 234
1, then 5, then 6 then 7 for channel slot 1567
When entering channel numbers with multiple digits, you have approx. three seconds
aer pressing a buon to complete the entry.
If you wish to enter a number consisting of only one, two or three digits, you can
speed up the entry procedure by keeping the buon pressed for longer on the last
digit or by pressing the OK buon.
13.2.3 Using the navigator (channel list)
> Press the OK buon.
The channel list navigator now appears. In TV mode, only TV channels are shown,
and in radio mode only radio channels are shown. The channel currently selected
is highlighted.