TechniSat TECHNISTAR S6

56
EN
The device cannot be
operated, or switched on
or o
Faulty data stream -->
Device blocked
Press and hold the On/
Standby buon on the
remote control for approx.
5 seconds.
Remove the mains plug
for approx. 5 seconds,
then switch the device
back on
Perform flash reset:
Caution!
In doing so, all personal
seings are deleted and
the device starts with
factory seings
> Remove mains plug
from the device
> Press standby and the
up arrow buon on the
device at the same time
and do not release.
> When the standby and
up arrow buon are
pressed reconnect the
mains plug
> Keep the buons
pressed for approx. 5
secs. and then release
both buons. The
display shows the
message “FLA5.”
USB device is not
detected
USB device is formaed in
the incorrect file system
Format USB device
in the FAT32 file system
Devices switches itself o
aer a specific time
Auto standby function is
switched on
Check auto standby
seing
and if required
switch o.