ACTIVE WTV: Machine configuration
1.2.6. LUB. DFLOORS (ONLY ON STEP)
This parameter defines the number of floors climbed, to be multiplied by ten, before the chains need
to be lubricated again.
To change the setting, press the CHANGE key and insert the value using the numeric keyboard.
Press ENTER key to confirm or BACK key to back forward.
Press HOME to confirm and save, FORWARD or BACK to scroll the pages.
The default value of this parameter is 16000.
1.2.7. LAST LUBR. (ONLY ON STEP)
This parameter displays the number of floors climbed since the chain was last lubricated.
Press HOME to confirm and save, FORWARD or BACK to scroll the pages.
1.2.8. N.LUBRIF (ONLY ON STEP)
This parameter displays the number of lubrication operations performed.
To reset the parameter, press RESET key.
Press HOME to confirm and save, FORWARD or BACK to scroll the pages.
1.2.9. STANDARD SETTINGS
This function clears the operating data of the machine and simultaneously resets the User menu, low
kit, UpDown table parameters to their default values. To launch the values restore press
STANDARD SETTINGS key
This function does not alter the language and the TV standard setting.
Page 13
To Next Page
Loading...
