Technogym ARTIS DBK0EQ - Wireless Guidelines; Home (Business to Consumer (B2 C)); Facility; Hotel (Business to Business (B2 B)); Maximum Number of Equipment Connected to One Access Point

ARTIS LINE with UNITY 4.0 Pre-Installation Requirements
Rev. 1.0
- 22 -
PIR-00028-EN - Uncontrolled copy if printed
10, 11, 12. Other channels: 2, 3, 4, 13, 14 might cause interference with Bluetooth
signal and it’s best to avoid them.
_Avoid in any case to broadcast the same SSID, through 2.4 and 5 GHz, at the
same time.
▪ LEASE TIME : at least three days;
▪ SESSION TIMEOUT disabled (Typically achieved setting the timeout = 0).
For more details about Access Point (AP), refer to the AP technical specications.
5.4 WIRELESS GUIDELINES
The following indications must be interpreted only as guidelines.
5.4.1 Home (Business to Consumer (B2C))
▪ Make sure the wi- signal is reachable by the equipment.
▪ If you use an Access Point / Wi-Fi router with a xed channel: avoid overlapping problems if,
in the same area, there are Access Points / Wi-Fi routers that use the same channel.
5.4.2 Facility / Hotel (Business to Business (B2B))
The wireless network should be installed and congured only by specialised companies and expert
technicians.
▪ The equipment must not be more than 25-30 metres LOS (line of sight) away from the Access
Point (analyse possible problems due to the presence of walls or other obstacles between the
Access Point and the equipment).
▪ If you use an Access Point with a xed channel: avoid overlapping problems if, in the same
area, there are Access Points that use the same channel.
5.5 MAXIMUM NUMBER OF EQUIPMENT CONNECTED
TO ONE ACCESS POINT
_Up to 5 devices: use a commercial Access Point.
_More than 5 devices: use a professional Access Point (see the technical datasheet).
For more details about Access Point (AP), refer to the AP technical specications.