ARTIS LINE with UNITY 4.0 Pre-Installation Requirements
Rev. 1.0
- 27 -PIR-00028-EN - Uncontrolled copy if printed
6. STANDARD TV TECHNICAL SPECIFICATIONS
6.1 INTRODUCTION
The data useful to antenna installers for checking the suitability of the antenna signal input to the
equipment with UNITY 4.0 are detailed below.
The readings in the tables below must be taken directly at the antenna input connector on the
equipment.
If the equipment is not connected to a terrestrial antenna or if it is connected but the signal is
interrupted by line disconnection switches, such as television control units or modulators or other
devices, the equipment will not be able to receive the signal to tune into the radio stations.
Key to abbreviations:
▪ dBμV = dB microVolt
▪ dBmV = dB milliVolt
▪ dBm = dB milliWatt
▪ SNR = Signal to Noise Ratio
Hereafter is shown the UNITY 4.0 – Digital TV standards broadcasting map:
To Next Page
Loading...
