ARTIS LINE with UNITY 4.0 Pre-Installation Requirements
Rev. 1.0
- 9 -PIR-00028-EN - Uncontrolled copy if printed
2. NETWORK DESIGN – CONFIGURATION AND
INSTALLATION
2.1 INTRODUCTION
▪ Installation and conguration of the network infrastructure (cables), of the network hardware
(Switch, Router, rewall) and any wireless network are at the expense of the customer.
▪ Technogym warns that the eciency and correct operation of the equipment and of the my-
wellness Cloud services depend on the technical characteristics of the hardware that is in-
stalled.
▪ Technogym does not guarantee the correct operation of the mywellness Cloud services in the
event of failure to comply with all the technical specications and warnings indicated.
2.2 NETWORK DESIGN AND INSTALLATION (Business-
to-Business (B2B))
During the network design and preparation phases, Technogym requests to be put in touch with
the technicians of the company performing the work, in order to obtain and provide technical infor-
mation, so that the network is installed and congured according to the required technical require-
ments.
Technogym can not be held responsible for failures due to site preparation, assembly and installa-
tion not correct.
2.3 CONFIGURATION AND INSTALLATION (Business-to-
Business (B2B))
Before performing the installation, the customer should inform Technogym that all the required
components have been provided and installed and that they operate correctly.
For this purpose, Technogym will send a check list form to the customer a few days before the date
set for installation, and will ask the customer to compile the form and send to the Technical Service
department. This check list form will allow Technogym to acquire the information related to the
installation status of the network for the equipment and thus check that everything that has been
requested to perform installation of the equipment is provided and operational.
To Next Page
Loading...
