Technogym KINESIS STATIONS - Support feet assembly

19
KINESIS STATIONS
C
E
B
G
H
D
D
C
F
ANCHORING TO THE FLOOR
To assemble the support feet, it is necessary to remove the rear protection panel.
Unscrew the screws (C), two on each side, and remove the handgrips (D).
Unscrew the screws (E), and remove the panel (F).
Fasten the support foot (B) to the module using the screw and washer (G), and tighten both screws (H).
Reassemble the panel (F) carrying out the above steps in reverse order.