EasyManua.ls Logo

Technogym KINESIS STATIONS - REPLACING THE CABLE; Cable replacement for handgrip operated models

Technogym KINESIS STATIONS
43 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
24
KINESIS STATIONS
B
A
A
REPLACING THE CABLE
Cables must always be replaced at the rst sign of wear, even if only the outer rubber protection is worn.
W
Carefully check the state of the cables once a month.
ALWAYS use cables supplied directly by Technogym.
To replace the cable, remove the rear protection panel as described in the paragraph Anchoring to the oor.
In High Pull, Low Pull, Overhead Press and Press, both weight stacks are operated by the
handgrips.
Lock pawl (A) by inserting a spanner in the hole provided.
Loosen screws (B) on both ends of the handgrip.
Remove pawl (A) and pull out the cable.
Lock pawl (A) to avoid damaging the cable.

Related product manuals