34
KINESIS STATIONS
B
B
C
A
A
EED
ADJUSTING CABLE TENSION
To adjust the cable tension, remove the rear protection panel as described in paragraph Anchoring to the floor.
Loosen screws (A) holding cable fasteners (B) in their respective slots.
Adjust the cable tension by turning eccentric adjusters (C).
It is also possible to move the pulleys upwards: holding the pulleys down,
move screws (D) into holes (E).
After this has been done, secure the cable fasteners in their respective
slots again.
Reassemble the rear protection panel.
To Next Page
Loading...
